Refer to your user's manual for the Recorder around the heat sources, operating temperature. such as television or oven. NR7401 Network Video Recorder Power POE Status HDD WAN LAN1 LAN2 LAN3 LAN4 Keep the Network Video Recorder Do not place the Network away from direct sunlight.
Page 3
Do not place the Network Video Do not touch the Network Video Recorder on unsteady surfaces. Recorder when it's lightening. Do not drop the Network Video Do not insert any object into the Recorder. Network Video Recorder, such as needles. EN - 2...
Hardware Installation Install the hard disk Before using the Network Video Recorder, please prepare a SATA hard disk to store the recorded video. 1. Make sure the power is off. 2. Use a screwdriver to loose five screws, and then slide to remove the upper cover. 3.
NR7401 supports PoE, if the Network Camera is PoE-compliant, it allows transmission of power and data via single Ethernet cable. 3. If your want to access NR7401 over the Internet, connect NR7401 to the Internet via WAN socket. 4. If you have external devices such as sensors and alarms, make connections from gen- eral I/O terminal block.
NR7401 will be displayed for you to configure the settings. 2. If you want to access NR7401 over the Internet, please assign a WAN IP address in the configuration page. There are three ways to get WAN IP address: DHCP (Dynamic IP), Static IP address, and PPPoE (DSL).
Configuration page Note If you want to record live video and playback the recorded video, you have to add devices to NR7401 in the Configuration page. For further setup, please refer to user's manual on the software CD. EN - 8...