10
EN
Power Zoom Lever
Recording
Start/Stop button
Lock Button
Power Switch
Dioptre
Adjustment
Control
PAUSE
3
1
2
GETTING STARTED
Grip Adjustment
1
Separate the Velcro strip.
2
Pass your right hand through the loop and grasp
the grip.
3
Adjust your thumb and fingers through the grip, to
easily operate the Recording Start/Stop button and
Power Switch and Power Zoom Lever. Be sure to
fasten the Velcro strip to your preference.
Viewfinder Adjustment
1
Set the Power Switch to "
pressing down the Lock Button located on the switch.
2
Pull out the viewfinder fully and adjust it manually
for best viewability.
3
Turn the Dioptre Adjustment Control until the
indications in the viewfinder are clearly focused.
Shoulder Strap Attachment
1
Following the illustration, thread the strap through
1
the eyelet
, then fold it back and thread it through
2
the buckle
. Repeat the procedure to attach the
other end of the strap to the other eyelet
under the Grip Strap . Confirm the strap is not
twisted.
Tripod Mounting
CAUTION
When attaching the camcorder to a tripod, extend its
legs to stabilise the camcorder. It is not advised to
use small sized tripods. This may cause damage to
the unit by falling over.
1
To attach the camcorder to a tripod, align the
direction stud and screw to the mounting socket and
stud hole on the camcorder. Then tighten the screw
clockwise. Some tripods are not equipped with studs.
(cont.)
" or "
" while
3
located