Adding/Replacing 2-Way Lcd Transmitters; Battery Replacement - Scytek electronic G777 Product Manual

Vehicle security system
Hide thumbs Also See for G777:
Table of Contents

Advertisement

Adding/Replacing One-Way Transmitters
To replace lost or stolen transmitters or to add additional transmitters into the system, have all
desired transmitters ready and follow the steps below.
Note: Up to 4 one-way transmitters can be programmed to operate the system. Any previously
stored transmitter code will be erased if it is not programed within the following sequence.
To program the transmitter(s):
1. Turn on the ignition key On, Off, On, Off, and back On.
· The siren will chirp 3 times.
2. Press and hold the Override switch for 5 seconds.
· The siren will chirp 5 times.
· The LED will illuminate.
3. Press Button 1 on the first transmitter.
· The siren will chirp once.
4. Repeat step 3 for each transmitter (up to 4).
5. Turn off the ignition key.

Adding/Replacing 2-way LCD Transmitters

When adding an optional 2-way LCD transmitter to the system, follow these steps:
1. Turn on the ignition key On, Off, On, Off, On, Off, and back On. (Key On 4 times)
· The siren will chirp 4 times.
2. Press and hold the Override switch for 5 seconds.
· The siren will chirp 4 times.
· The LED will illuminate.
3. Press Button 1 on the first transmitter, then on the second transmitter.
· The siren will chirp once for each transmitter learned.
4. Turn off the ignition key.

Battery Replacement

Your Remote Transmitter uses battery type 2016 for G777,G27 and 23A for A777,A20 which will
require replacement in time. Depending on the amount of use, the battery may last up to 24
months or more before it needs replacement.
When the battery needs replacing, the system's operating range will decrease or the transmitter
LED may not be as bright.
In order to change the battery, first remove 2 screws from the back of the transmitter and
separate the top and bottom halves of the case.
While replacing the battery make sure that the positive and negative terminals are positioned
correctly, then carefully reassemble the transmitter case.
(2 LCD remotes maximum)
A777, A20, G777, G27
Page 3

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G27A777A20

Table of Contents