Lcd Transmitter Battery Replacement; Way Lcd Remote Transmitter Description - Scytek electronic G777 Product Manual

Vehicle security system
Hide thumbs Also See for G777:
Table of Contents

Advertisement

2-way LCD Remote Transmitter Description

Page 1
Button 1 Arms and Locks the system and when held for 5 seconds, activates the system's Panic feature.
Button 1 also locks the doors when the system is in Valet Mode.
Button 2 Disarms and Unlocks the system. Pressing Button 2 again operates the Passenger Unlock feature
(if installed). Button 2 also unlocks the doors when the system is in Valet Mode.
Button 3 Activates the Auxiliary 1 output normally used for trunk release (note trunk icon on button).
Button 4 Activates the Remote Start feature.
Button 5 is the Confirmation, Programming and the Page Shift button. Quickly pressing button 5 will activate
the Page 2 function. Pressing button 5 for 2 seconds activates the system's confirmation feature which will
then display the current status of the system (armed, disarmed, engine running, etc.).
Page 2
Button 1 Silently Arms/Locks the system.
Button 2 Silently Disarms/Unlocks the system.
Button 3 Activates the Auxiliary 2 output.
Button 4 Aux 3 or Factory Rearm output.
Button 5 Not Implemented. Page 3 & 4 are used as Page 1 & 2 for second car operation

LCD Transmitter Battery Replacement

Your Pager Remote Transmitter uses a 1.5 volt AAA alkaline battery, which will require replacement in time.
Depending on the amount of use, the battery may last up to 3 months before it needs replacement. When
the battery needs replacing, the system's operating range will decrease, the LCD display will show only one
of three bars in the battery icon, or the display and sounds may suddenly stop and start as the battery
voltage drops below minimum.
In order to change the battery, first slide the battery door locking pin to the side. Carefully slide the battery
cover downward until it is free. While replacing the battery make sure that the positive and negative
terminals are positioned correctly, then carefully reassemble the transmitter case.
Button 1
Button 2
Button 3
Button 4
Button 5
A777, A20, G777, G27
Page 1

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

G27A777A20

Table of Contents