Indiglo ® Night-Light Feature; Battery Replacement; Removing The Battery; Replacing The Battery - Timex HEALTH TOUCH PLUS User Manual

INDIGLO NIGHT-LIGHT FEATURE
®
1. Press INDIGLO button to activate the night-light for several seconds.
®
2. While night-light is on, press any button to keep the light on for an additional few seconds.

BATTERY REPLACEMENT

The Health Touch ™ Plus watch uses one CR2032 battery.
Change the battery if the display fades and becomes hard to read.
To change the battery in your watch, you will need:
• A small Phillips-head screwdriver
• A pair of tweezers
TIP: Changing the battery requires manipulation of several small parts. Change the battery on a flat,
light-colored surface.

REMOVING THE BATTERY

1. On the back of the watch, use the Phillips-head screwdriver to remove the four screws at the corners of
the back cover.
2. Remove the back cover and the clear plastic film covering the battery compartment.
3. Hold the watch interior in place with your thumb and use the tweezers to lift one of the metal tabs on the
battery cover until the cover comes loose.
4. Use the tweezers to grasp the tab on the middle of the battery cover, and carefully lift the cover off of the
battery.
5. Carefully insert the corner of the tweezers into the depression near the battery and lever the battery out
of the compartment.
DO NOT DISPOSE OF BATTERY IN FIRE. DO NOT RECHARGE. KEEP LOOSE BATTERIES AWAY FROM CHILDREN.

REPLACING THE BATTERY

1. Insert the new battery with the positive (+) side up.
2. Replace the metal battery cover and press gently until it snaps into place.
3. Replace the clear plastic film.
4. Make sure the black rubber ring is seated evenly in the groove around the battery compartment.
5. Replace the back cover of the watch in the same orientation it was in when you removed it.
6. Use the Phillips-head screwdriver to replace the four screws.
NOTE: After the battery is replaced, workout data is deleted.
CR2032
9