Snow Blower Storage - Alamo Great White 8650-A Operator's Manual

Relieve hydraulic pressure prior to doing any maintenance or repair work
WARNING!
on the Implement. Place the Implement on the ground or securely
blocked up, disengage the PTO, and turn off the tractor engine. Push
and pull the Remote Cylinder lever in and out several times prior to
starting any maintenance or repair work.

12. SNOW BLOWER STORAGE

Properly preparing and storing the snow blower at the end of the season is critical to maintaining its appearance
and to help ensure years of dependable service. The following are suggested storage procedures:
1. Thoroughly clean all debris off the implement to
prevent damage from rotting grass and standing
water.
2. Lubricate all implements points and fill gearbox oil
levels as detailed in the maintenance section.
3. Tighten all bolts and pins to the recommended
torque.
4. Check the implement for worn and damaged parts.
Perform repairs and make replacements
immediately so that the implement will be ready
for use at the start of the next season.
5. Store the implement in a clean, dry place with the
implement resting securely on blocks or at ground
level.
6. Keep the drivelines yokes or hydraulic hoses from
sitting in water, dirt and other contaminants.
7. Use spray touch-up enamel where necessary to
prevent rust and maintain the appearance of the
implement.
DANGER!
Never allow children to play on or around the Tractor and Implement. Children can slip or
fall off the Equipment and be injured or killed. Children can cause the Implement to shift or
fall crushing themselves and others.
8650A 07/05
© 2005 Alamo Group Inc.
OPERATION
(S3PT-9)
(SG-25)
Operation Section 4-26