Using a Synapse Cable with the Scanner
1. Connect the Synapse Adapter cable into the bottom of the scanner.
2. Connect the Synapse Adapter cable to the Synapse Interface cable .
3. Connect the Synapse Adapter cable's flying power lead to the receptacle in the
Synapse Interface cable (refer to
4. Plug the Synapse Interface cable into the host device.
5. Connect an appropriate power supply to the power receptacle in the Synapse
Interface cable.
Wand Emulation, OCIA, OCR, Keyboard Wedges
See the instructions packed with the appropriate Synapse cable. An adapter cable is required.
See
Figure 2-4 on page
Figure
2-6.
2-4).
Set Up
2-7