Pos Application; System Menu - Symbol Phaser P460 Reference Manual

Phaser Series Scanner Product Reference Guide
Press <ENTER> on this screen to erase the data; press <BK> to retain the data.

POS Application

Whenever the scanner detects that a communication cable has been inserted, it switches to
the POS application. In POS mode, the scanner can transmit bar codes and optional
quantities to the POS host. The POS screen appears as follows:
Scanned bar codes automatically transmit to the host. Keyed bar codes transmit once you
press the <ENTER> key. To enter a quantity, press the * key prior to scanning or keying any
bar code data. Once you press the * key, the following screen appears:
Key in a quantity followed by the <ENTER> key. The SKU entry screen reappears. The
scanner sends the SKU to the host the keyed-in amount of times. For instance, if you type in
a quantity of 6, the scanner sends that SKU to the host six times as if the SKU were scanned
six times.

System Menu

The system menu contains utilities to allow the user to set up the scanner. To access the
System Menu, press the <FN>* key combination to reset the scanner, and then <FN><BK>
within the first 10 seconds after the power up beep (while the
still shown). The scanner displays:
3-4
Confirm file erase
<EN>=Y <BK>=N
Figure 3-8. Data Erasure Confirmation
SCAN: _______________
_____________________
Figure 3-9. POS Application Screen
QTY: _____
Figure 3-10. POS Quantity Screen
Phaser P460 Scanner
0. System Setup
Figure 3-11. Setup Screen
Banner Screen on page 3-1 is