Hex Head Screw - Craftsman 113.19771 Owner's Manual

REMOVE SKTDS FROM BASE
MOUNTING SAW
1.
.FroT among the loose parts, find the following
hardware:
8
Hex Head Screws,5/16_1g x 5/g
8^
.Lockwashers, 5/.l6 in. exierna'tlype
1 6 W a s h e r s , 1 1 / 3 2 t D
8 H e x J a m N u t s , 5 / l G l g
2. Place saw on legs so that holes in bottom of saw line
up
with holes marked X in top of legs.
3. lnstall screws, washers and nuts as shown.
lf you mount the saw on any other Craftsman
base or flat
bench, make sure Elevation Crank has propei clearance
to
rotate. The saw must be bolted down. position
saw to slope
sligh-tly rearward, so when the carriage is instailed it wiil
not
roll forward due to gravity.
R . H . S T I F F E N E R
S A W B A S E
HEX HEAD SCREW
F L A T W A S H E R -
S T I F F E N E R
F L A T W A S H E R
loc<wassen /
H E X N U T
ATTACH ELEVATION CRANK.
Be sure setscrew is tightened on flat of shaft.
ELEVATE ARM TO ITS MAXIMUM HEIGHT.
Remove shipping block and discard.
r o