Antikickback Pawls - Craftsman 113.19771 Owner's Manual

assemblY and alignment
A L I G N M E N T O F S P R E A D E R F O R R I P P I N G '
W A R N I N G : N E V E R P O S I T I O N T H E
G U A R D O R
ir,r'iiiiickaAcK AssEMBLY wlrH PowER oN;
NoR
pdi;iioN-attrrlrrcreAcr PAWLs BY GRASPING
P A W L S O R S P R E A D E R .
2. Install Blade Guard.
a. Sight (visually) to check for proper alignment
of
ipieaOer with saw blade as shown' lf the spreader
is
not aligned, adjust it as follows:
(1) Loosen two hex nuts' one on each side of
sPreader.
(2) Rotate hex nuts with fingers until the spreader
is directlY in line with saw blade'
(3) Tighten both hex nuts firmlY'
3. Check and Adiust the spreader as follows:
a. Loosen the antikickback spreader adjusting
wing
screw and with the
"tab" position the antikickback
and spreader assembly near the bottom of the blade
a n d t i g h t e n .
ANTI KICKBACK, SPREADER
A D J U S T I N G W I N G S C R E W
ANTIKICKBACK PAWLS
FENCE LOCATIONS
Position (A) .is used for most cutoff and narrow
ripping
oi"t.iionf.
Position (B) is used for maximum width
i i p p i n g . P o s i t i a . ( C ) i s u s e d t o a c h i e v e m a x i m u m c r o s s c u t
capacity in thin work.
Now that you have assembled and aligned
your saw' you
are ready to proceecl with operating controls.section
of this
manual. Refer to trouble shooting section if saw
does not
;;;;;
sitisfactorilv or anv problems should surface after
using the saw.
B
rt
C A
rl
l 9