Digital Connections - JVC RX-884RBK Instructions Manual

Digital connections

This receiver is equipped with three DIGITAL IN terminals — one digital coaxial
terminal and two digital optical terminals.
To enjoy Dolby Digital, you have to connect the source components using the DIGITAL
IN terminals.
You can connect any component to any one of the digital terminals using the digital
coaxial cable (not supplied) or digital optical cable (not supplied).
DBS tuner
DBS
DVD player
DVD
CD player
MD recorder
IMPORTANT:
• When connecting the DVD player or the DBS tuner using the digital terminal,
you also need to connect it to the video jack (either composite video terminal
or S-video terminal) on the rear. Without connecting it to the video jack, you
can view no playback picture.
• After connecting the above components using the DIGITAL IN terminals, set
the following correctly if necessary.
– Select the digital input mode correctly. For details, see "Selecting the Input
Mode" on page 18.
– Set the digital input (DIGITAL IN) terminal setting correctly. For details,
see "Digital Input (DIGITAL IN) Terminal Setting" on page 20.
When the component has a digital
coaxial output terminal, connect it
to the DIGITAL 1 (DBS) terminal,
using the digital coaxial cable (not
supplied).
When the component has a digital
optical output terminal, connect it
to the DIGITAL 2 (DVD) or
DIGITAL 3 (CD) terminal, using
the digital optical cable (not
supplied).
Before connecting a
digital optical cable,
unplug the protective
plug.
Notes:
• When shipped from the
factory, the DIGITAL IN
terminals has been set for use
with the following
DIGITAL IN
components.
PCM/DOLBY DIGITAL
– DIGITAL 1 (coaxial): For
DBS tuner
– DIGITAL 2 (optical): For
DVD player
DIGITAL 1 (DBS)
– DIGITAL 3 (optical): For CD
player
DIGITAL 2 (DVD)
• When you want to operate the
CD player or MD recorder
DIGITAL 3 (CD)
using the COMPU LINK
remote control system,
connect the target component
also as described in "Analog
connections" (see page 9).
12