Using The Dap Modes - JVC RX-884RBK Instructions Manual

Using the DAP Modes

You can use five DAP modes — "Live Club, Dance Club, Hall, Pavilion, and
Headphones" for any source.
Among the DAP modes, "Headphones" is very special. It can create the same stereo
sound as you listen through the speakers off air while listening to a source using
headphones. So, you can feel as if you were not using the headphones and listening to
music in a room.
If the digital input is selected to play the source encoded with Dolby Digital, you can
only select "Headphones."
On the front panel:
1. Press DSP MODE.
The current DSP mode appears on the display.
2. Turn MULTI JOG until the mode (LIVE CLUB, DANCE
CLUB, HALL, PAVILION, or HEADPHONE) you want
appears on the display, while the indication of the previous
step is still on the display.
The DSP indicator also lights up on the display.
As you turn it, the DSP modes change as follows:
THEATER
DSP OFF
3D THEATER
When the digital input is selected to play the source encoded with Dolby
Digital:
DIG-THEATER
DSP OFF
LIVE CLUB: Gives the feeling of a live music club with a low ceiling.
DANCE CLUB: Gives a throbbing bass beat.
HALL: Gives clear vocal and the feeling of a concert hall.
PAVILION: Gives the spacious feeling of a pavilion with a high ceiling.
HEADPHONE: Gives a spacious stereo effect when listening with headphones.
DSP OFF: No DSP mode is applied.
For the other modes, see pages 35 and 43.
If you need to make any adjustment, go to the following steps.
3. Adjust the speaker output levels as follows.
1) Press BALANCE/SURROUND ADJUST repeatedly
until one of the indications appears on the display.
"REAR L LEVEL": To adjust the left speaker level.
"REAR R LEVEL": To adjust the right speaker level.
2) Turn MULTI JOG to adjust the selected speaker output
level (from –10 dB to +10 dB), while the indication of the
previous step is still on the display.
3) Repeat 1) and 2) to adjust the other speaker output
levels.
DANCE CLUB
LIVE CLUB
3D DRAMA 3D ACTION
HEADPHONE
3D DIGITAL
DSP MODE
MULTI JOG
HALL
PAVILION
HEADPHONE
BALANCE/SURROUND
ADJUST
MULTI JOG
Continued to the next page.
Notes:
• The DAP mode is not used
with the other DSP modes
such as the 3D-PHONIC
mode and the Surround
mode. When the DAP mode is
turned on, the other DSP
mode, if used, will be turned
off.
• When the DAP mode is used
with the SEA mode (see page
32), sounds may be distorted.
If this happens, turn off the
SEA mode.
Note:
The indicator of the selected
DSP mode also lights up on the
display while selecting.
Note:
When you select
"HEADPHONE," you cannot go
to the following steps. No
adjustments can be made for
"HEADPHONE."
Note:
You cannot adjust the rear
speaker levels when "REAR
SPK" is set to "NONE" (see
page 20).
38