Specifications; Troubleshooting Guide - Heath Zenith 4190 Series User Manual Manual

SPECIFICATIONS

Range . . . . . . . . . . . Up to 30 ft. (9.1 m)
Sensing Angle . . . . . Up to 180°
Electrical Load. . . . . See rating on fixture
Sensor Capacity . . . Upto360Watts(3.0A.)
Power Requirements 120 VAC, 60 Hz
Operating Modes . . . TEST, AUTO, and
Time Delay . . . . . . . 1, 5, 10 minutes
D B Timer . . . Off, 3, 6 hours, dusk-to
®
ual rite
HeathCo LLC reserves the right to discontinue
products and to change specifications at
any time without incurring any obligation
to incorporate new features in products
previously sold.
SYMPTOM POSSIBLE CAUSE
Light will not
1. Light switch is turned off.
come on. 2. Bulb is loose or burned out.
3. Fuse is blown or circuit breaker
4. Daylight turn-off is in effect
5. Incorrect circuit wiring, if this is
Light comes on
1. Light control may be installed in
in daylight.
2. Light control is in Test. (Set
Light comes on 1. Lightcontrolmaybesensingsmall
for no apparent
reason.
2. Sensitivity is set too high. (Re-
204031-02
[varieswithsurrounding
temperature]
for maximum wattage
Maximum Tungsten
Incandescent
MANUAL MODE
dawn

TROUBLESHOOTING GUIDE

is turned off.
(recheck after dark).
a new installation.
a relatively dark location.
control switch to an ON-TIME
position.)
animals or automobile traffic
(Reduce sensitivity).
duce sensitivity.)
SYMPTOM POSSIBLE CAUSE
Light stays on
1. The sensor is pointed toward
continuously.
2. Light control is in Manual Mode.
3. Light control is in D
4. Sensitivity is set too high. (Re-
Light flashes
1. Light control is in the Test
on and off.
2. Heat being reflected from other
7
a heat source like an air
vent, dryer vent, or brightly-
painted heat-reflective surface.
(Reduce sensitivity.)
(Switch to Auto.)
ual
mode.
duce sensitivity.)
m o d e a n d wa r m i n g u p.
(Flashing is normal under
these conditions).
objects may be affecting the
sensor. (Reduce sensitivity.)
B
®
rite