Bulb Replacement; Specifications - Heath Zenith DualBrite SL-4290 Series User Manual

❒ Walk through the coverage area noting
where you are when the lights turn on.
Move the sensor head left or right to
change the coverage area.
IMPORTANT: Grasp the sensor only as
shown and turn the entire sensor. Any
other method may damage the sensor.
Do not force the sensor past the stop-
ping points.
Rotating Sensor Head to Change
Coverage Area
❒ If you need to change the sensitivity,
temporarily remove the fixture and make
the adjustment. Too much sensitivity may
increase false triggering.
❒ Set the amount of TIME you want the light
to stay on after motion is detected. (1, 5,
or 10 minutes).
❒ Set the amount of time after dusk you want
the lights on accent level.

BULB REPLACEMENT

If lantern has an open bottom, insert bulb
through opening and screw into socket.
If lantern has a closed
bottom, follow the steps
below to replace bulb.
1. Place one hand
under lower glass
assembly and un-
screw decorative
screws holding
lower glass as-
sembly to top of
fixture.
2. Replace bulb.
3. Reattach
glass assembly
to fixture top us-
ing decorative
screws.

SPECIFICATIONS

Range .........Up to 30 ft. (9.1 m) [varies with
Sensing Angle ............................Up to 150°
Electrical Load .... Up to 100 Watt Maximum
Sensor Capacity ..... Up to 360 Watt (3.0 A.)
Power Requirements ......... 120 VAC, 60 Hz
Operating Modes ............ TEST, AUTO, and
Time Delay ........................ 1, 5, 10 minutes
D B timer ...................... Off, 3, 6 hrs,
®
ual rite
6
Decorative Screws
Light
Bulb
lower
Lower Glass
Assembly
surrounding temperature].
Tungsten Incandescent
Maximum Tungsten
Incandescent
MANUAL MODE
Dusk-to-Dawn
598-1277-03