Operation; Manual Mode; Specifications - Heath Zenith 4395 Installation And Operating Instructions Manual

Motion sensing diecast metal lantern
Table of Contents

Advertisement

Available languages

Available languages

The sensor is less sensitive to motion directly towards it
and more sensitive to motion across coverage area.
Motion
Least Sensitive

OPERATION

Mode:
On-Time
Test
5 Seconds
1, 5, or 10
Auto
Minutes
To Dawn*
Manual
* resets to Auto Mode at dawn.
Note: When first turned on wait about 1
the circuitry to calibrate.

MANUAL MODE

Manual mode only works at night
because daylight returns the sensor
to AUTO.
Flip the light switch off for one sec-
ond then back on to toggle between
AUTO and MANUAL MODE.
Manual mode works only with the
ON-TIME switch in the 1, 5, or
10 position.
Motion
Sensor
Most Sensitive
Works:
Day
x
/
minutes for
1
2
1 Second OFF
then...
... back on.
MODE SWITCHING SUMMARY
TEST
AUTO
MANUAL MODE
* If you get confused while switching modes, turn the power
off for one minute, then back on. After the calibration time
the control will be in the AUTO mode.
ADJUSTMENT OF COVERAGE AREA
Night
The sensor on this light fixture detects "motion" by the
x
movement of heat across the coverage area. However,
x
following are examples of objects that also produce heat
and can cause the sensor to trigger:
x
• Pools of Water
• Dryer Vents
• Heating Vents
If you suspect that a heat source of this type is triggering
the sensor, reduce the sensitivity.
Range ...............................Up to 30 ft. (9.1 m) [varies with
Sensing Angle...................180°
Electrical Load .................Up to 100 Watt Maximum
Bulb Type .........................Medium Base, Type "A", 100
Sensor Capacity . ...............360 Watt (3.0 A) Maximum
Power Requirements . ........120 VAC, 60 Hz
Operating Modes .............TEST, AUTO, and MANU-
ON-Timer . .......................1, 5, 10 minutes
Test Timer . .......................5 Seconds
Manual Mode Timer . .......Dusk-to-Dawn
HeathCo LLC reserves the right to discontinue products
and to change specifications at any time without incurring
any obligation to incorporate new features in products
previously sold.
6
ON-TIME Switch at 1, 5, or 10
minutes
Flip light switch off for one
second then back on*
• Air Conditioners
• Animals
• Automobile Traffic

SPECIFICATIONS

surrounding temperature].
Tungsten Incandescent
Watt Maximum
Tungsten Incandescent
AL MODE
204069-01

Advertisement

Table of Contents
loading

Table of Contents