Precor TRM 425 Owner's Manual page 71

Treadmill 200 Series Assembly Guide
To attach the cables to the console:
1. Ask your assistant to hold the console over the console bracket while you
carefully route the following console cables:
a. Insert the stop switch cable (1) with the two connector tabs pointing down.
You will feel the cable lock into place.
b. Insert the base unit data cable (2).
c. Once both of these cables are connected, tuck the cables into the left side
of the cable retainer (5), as shown in the figure below.
d. Insert the console ground cable (3) with the round side positioned upward.
e. Insert the touch heart rate cable (4) with the front two tabs pointing down.
f. Once both of these cables are connected, tuck the cables into the right side
of the cable retainer (5).
Important: Make sure that all four cables are tucked into the cable retainer before
you place the console on the bracket. Place excess cable in the console recess where
the cables insert.
Figure 12: Cable guide on back of console
2. Set the console onto the console bracket. It should sit flush on the bracket
without gaps. If there is a gap, check to make sure that no cables are being
pinched between the console and the console bracket.
Note: Do not secure the console to the bracket until instructed to do so.
Figure 13: Console should fit snuggly on console bracket
10