Mxd-430 Installation; Power Via Power Over Ethernet - AMX MXTD-1000 Instruction Manual

MXD-430 4.3" X Series Wall/Flush Mount Touch Panel

MXD-430 Installation

Refer to A Note About Wall and Rack Installation on page 5 for important notes
on thermal concerns with Wall and Rack Installations.
The MXD-430 may be installed directly into a solid surface environment, using either solid surface screws or the
included locking tabs for different mounting options.
Once installed, the MXD-430 is contained within a clear outer housing known as the Backbox (FIG. 41). This Backbox
is removed before installing the device into a wall or when using the optional Rough-In Box accessory (FG039-19).
FIG. 41 MXD-430 Backbox
For typical mounting surfaces, such as drywall, use the locking tabs as the primary
method for securing the Backbox to the surface. For thin walls or solid surfaces, use
mounting screws (not included).

Power via Power Over Ethernet

Power for the MXD-430 is supplied via Power Over Ethernet (PoE), utilizing an AMX-certified, capacitive touch-
compliant PoE injector or other approved AMX PoE power source. The incoming PoE Ethernet cable should be
connected to the RJ45 port on the MXD-430 (FIG. 40).
46
Locking tab
MXD/T-1000, MXD/T-700 and MXD-430 Modero X Series® Touch Panels
Backbox
Locking tab