Maintenance; Maintenance Schedule - Jonsered FR2318 FA4X4 Operator's Manual

Maintenance schedule

The following is a list of the maintenance which should be conducted on the machine. For those points not described in this manual,
visit an authorised service workshop.

Maintenance

Cleaning
Check the engine's oil level
Check the engine's cooling air intake
Check the fuel pump air filter
Check the steering wires
Check the brakes
Check the battery
Check the safety system
Check nuts and screws
Check for fuel and oil leakage.
Clean around the silencer
Check the muffler
1)
Change engine oil
Replace the air filter's prefilter2)
Check the cutting deck
Check the air pressure in the tyres, 60 kPa/8.5 PSI.
Lubricate the belt adjuster
Lubricate joints and shafts
Check the V-belts
Check the transmission's cooling fins
Check transmission oil level
Check/adjust parking brake
Checking and adjusting of throttle wire
Clean the engine's and transmission's cooling fins
Replace the air filter's pre-filter and paper filter
Replace the fuel filter.
Replace the spark plug.
Check the need to change the oil
system
Check the fuel hose. Replace if necessary .
1)
First change after 8 hours.
be lubricated twice a week.
X = Described in this operator's manual
O = Not described in this operator's manual
WARNING! No service procedures must be conducted on the engine or cutting unit unless:
!
The engine is switched off.
The ignition key is removed.
The ignition cable has been removed from the spark plug.
The parking brake is applied.
The cutting unit is disengaged.
IMPORTANT INFORMATION When the machine is in operation the hoses are under high pressure. Do not try to connect or
disconnect the hoses when the hydraulic system is operational. This can result in serious personal injuries.
Maintenance
3)
3)
2,4)
2)
4,5)
in the gearbox/hydraulic
4)
2)
Clean and replace the filter more often in dusty conditions.
4)
Conducted by authorised service workshop.
Daily
At least once a
maintenance
year
before starting
X
X
X
X
X
X
X
X
O
O
O
X
3)
If the machine is used daily it should
5
First change after 8 hours. (Only 4x4-machines)
Maintenance interval
in hours
25 50 100
X
X X
X
X
X
X
X
O
O
X
X
O
X
X
X
O
O
English
200
O
– 17