Universal Garage Door Opener (Homelink®) - Dodge Viper SRT 2013 User Manual

Table of Contents

Advertisement

E LE C TR O NICS
Auto Unlock Doors On Exit
• To have all of the vehicle doors unlock when any door is opened:
• Enter your vehicle and close all the doors, and fasten your seat belt.
• Cycle the ignition switch between the LOCK and ON position four times, ending in the
LOCK position (do not start the engine).
• Press the power door UNLOCK switch to unlock the doors. A single chime will
indicate that programming is complete.
Sound Horn With Lock
• To turn the horn chirp on or off when the doors are locked:
• Press the LOCK button for at least 4 seconds, but no longer than 10 seconds. Then,
press the PANIC button while still holding the LOCK button.
• Release both buttons at the same time.
Flashing Lights With Lock
• The turn signal lights flashing, when the doors are locked or unlocked, feature can be
turned on or off. To turn this feature on or off:
• Press and hold the UNLOCK button for at least 4 seconds, but no longer than 10
seconds. Then, press and hold the LOCK button while still holding the UNLOCK
button.
• Release both buttons at the same time.
UNIVERSAL GARAGE DOOR OPENER (HomeLink®)
• HomeLink
®
replaces up to three hand-held transmitters that operate devices such as
garage door openers, motorized gates, lighting or home security systems. The
HomeLink
®
unit is powered by your vehicles 12 Volt battery.
• The HomeLink
buttons that are located in the overhead console or sunvisor designate
®
the three different HomeLink
• The HomeLink
®
indicator is located above the center button.
Before You Begin Programming
HomeLink®
• Be sure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
• For more efficient programming and ac-
curate
transmission
frequency signal it is recommended that
a new battery be placed in the hand-held
transmitter of the device that is being
programmed to the HomeLink
• Erase all channels before you begin programming. To erase the channels, place the
ignition switch into the ON/RUN position, then press and hold the two outside
HomeLink
buttons (I and III) for up 20 seconds or until the red indicator flashes.
®
60
channels.
®
of
the
radio-
®
system.

Advertisement

Table of Contents
loading

This manual is also suitable for:

2014 srt viper

Table of Contents