Table of Contents
Advertisement
Fuel Economy
Push and release the UP
highlighted. Push the RIGHT
following:
• Average Fuel Economy/Miles Per Gallon (MPG Bar graph)
• Range To Empty (RTE)
• Current Miles Per Gallon (MPG)
UNIVERSAL GARAGE DOOR OPENER (HomeLink)
• HomeLink replaces up to three hand-held transmitters that operate devices such as
garage door openers, motorized gates, lighting or home security systems. The
HomeLink unit is powered by your vehicles 12 Volt battery.
• The HomeLink buttons that are located in the overhead console or sunvisor designate
the three different HomeLink channels.
• The HomeLink indicator is located above the center button.
Before You Begin Programming HomeLink
• Be sure that your vehicle is parked out-
side of the garage before you begin pro-
gramming.
• For more efficient programming and ac-
curate
transmission
frequency signal it is recommended that
a new battery be placed in the hand-held
transmitter of the device that is being
programmed to the HomeLink system.
• Erase all channels before you begin pro-
gramming. To erase the channels, place
the ignition switch into the ON/RUN po-
sition, then press and hold the two out-
side HomeLink buttons (I and III) for up to 20 seconds or until the red indicator flashes.
NOTE:
• Erasing all channels should only be performed when programming HomeLink for the
first time. Do not erase channels when programming additional buttons.
• If you have any problems, or require assistance, please call toll-free 1-800-355-3515
or, on the Internet at HomeLink.com for information or assistance.
or DOWN
arrow button until the Fuel Economy icon is
arrow button and the next screen will display the
of
the
radio-
E L E C T R O N I C S
HomeLink buttons
151
Advertisement
Table of Contents
