Table of Contents
Advertisement
DIMM 4 (DDR4)
DIMM 3 (DDR3)
DIMM 2 (DDR2)
DIMM 1 (DDR1)
DIMM 8 (DDR8)
DIMM 7 (DDR7)
DIMM 6 (DDR6)
DIMM 5 (DDR5)
Complete the following steps to install DIMMs:
1. Read the safety information beginning on page v, and "Installation guidelines"
on page 7.
2. Turn off the server and peripheral devices, and disconnect the power cords and
all external cables.
3. Remove the server cover (see "Removing the cover and bezel" on page 8).
Attention:
To avoid breaking the retaining clips or damaging the DIMM
connectors, open and close the clips gently.
4. Open the retaining clip on each end of the DIMM connector.
5. Touch the static-protective package containing the DIMM to any unpainted metal
surface on the server. Then, remove the DIMM from the package.
6. Turn the DIMM so that the DIMM keys align correctly with the slot.
7. Insert the DIMM into the connector by aligning the edges of the DIMM with the
slots at the ends of the DIMM connector. Firmly press the DIMM straight down
into the connector by applying pressure on both ends of the DIMM
simultaneously. The retaining clips snap into the locked position when the DIMM
is firmly seated in the connector. If there is a gap between the DIMM and the
Chapter 2. Installing options
19
Advertisement
Table of Contents
