Optional Equipment; Fireback Installation - Travis Industries 864 TRV GreenSmart Installation Manual

Optional Equipment

Fireback Installation

WARNING: Turn off gas
to the appliance and
make sure it has fully
cooled prior to
conducting service.
1 Remove the glass frame
and logs.
2 Install the firebacks
following the directions
to the right (note: the
hearth plate is
discarded).
© Travis Industries
(for qualified installers only)
b
Remove the exhaust restrictor
(4 screws hold it in place).
a
Remove the rear burner.
NOTE: when replacing make sure the
burner is properly aligned and the holes on
the tabs on the burner insert over the pins
on the burner stand.
Remove the clips on both sides (these clips have key-
a
holes, allowing removal without removing the screw)
5/16" Nutdriver
d
Place the floor
firebacks in place.
4090227
Remove the rear air deflector
c
(two screws hold it in place).
Remove the screw holding
d
the accent light assemblies in
place. Re-position the
assemblies so they are laying
flat, this allows the rear
fireback to install.
Place the rear fireback in place. The side
b
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
Place the side firebacks
c
in place. Secure using
the screws and clips
removed in step "a".
100-01220_000
57