Optional Equipment; Fireback Installation - Travis Industries 564 Installation Manual

Optional Equipment

Fireback Installation

WARNING
Turn off gas to the
appliance and make
sure it has fully
cooled prior to
conducting service.
1 Remove the
glass frame and
logs.
2 Remove the
grate (replace
after fireback
installation).
Remove and
discard the
hearth plate.
3 Install the
firebacks
following the
directions
below. Select
either the
straight brick or
herringbone
brick pattern to
face outwards.
N O T E :
Due to the
construction of the
ceramic firebacks,
you may need to re-
position the
firebacks to achieve
the correct
alignment.
4 Restore the
fireplace to the
correct
configuration.
© Travis Industries
1/4" Nutdriver
Remove the grate
(replace after fireback installation).
Loosen this screw and
slide the bracket up.
Remove the clip and screw located on the
a
firebox ceiling near the front (both sides).
1/4" Nutdriver
NOTE: Place the fireback
so the vertical grout line on
the edge of the fireback is
facing the rear.
b
Loosen this screw and slide the bracket up. Place the floor
firebacks in place (under the bracket). Slide the bracket
down and tighten the screw to secure the firebacks.
(for qualified installers only)
Remove and discard
the hearth plate
4 0 7 0 6 2 0
5 9
Place the rear fireback in place. The side
fireback holds the rear fireback in place -
hold the rear fireback while installing the
side fireback.
c
Place the side firebacks
d
in place.
Replace the clips and screws
e
removed in step "a" to secure
the side firebacks..
100-01188_000