Controllers - Bathroom Deluxe
Installation
1.
Determine the most suitable
position for the controller.
2. Mark and drill three holes,
locating the cable access hole
as shown (Fig.1).
3. When running a cable through
the access hole ensure the
connector end of the cable
is located nearest to the
controller (Fig.2).
4. Affix the double sided self-
adhesive seal to the back of
the controller (Fig.3).
5. Carefully remove the face plate
from the controller. Do this
by placing your thumbs on
the front digital display while
hooking your fingers behind
the top plate and gently push
down as shown (Fig.4). Do not
use a screwdriver as this may
damage the controller.
6. Connect the cable to the
bathroom controller. Feed
excess cable lengths into the
wall cavity to avoid pinching of
cables between the wall and
the controller.
7.
Fix bathroom controller to the
wall using appropriate fixings.
Avoid the use of impact
drills and over-tightening of
fixings as this may damage the
controller.
8. Remove the protective plastic
from the controller face and
replace the face plate.
18 | Continuous Flow Water Heater Installation Guide 04-12
Outline of Water Controller
181
Securing
Screw
Ø20 Cable Access
195
Controller Cable
Backing Seal
Fig.1
Connector
Fig.2
Remove
to expose
self-adhesive
Fig.3
Fig.4