W
S
K
I
INDOW
LIDER
IT
Your window slider kit has been designed to fit most standard "vertical"
and "horizontal" window applications. However, it may be necessary to
improvise/modify some aspects of the installation procedures for certain
types of windows.
N
: If the window opening is less than the minimum length of the
OTE
window slider kit, cut the piece with a hole in it, so that it is the correct size
to fit the window opening. Leave the hole in the window slider kit intact.
Never cut out the hole in the window slider kit.
1. Open the window and insert the window kit into the open gap.
2. Close the window until the window kit is held securely. You may need to adjust the size of the window kit
and secure it with screws. This technique may also be used for sash windows.
3. Fit the exhaust hose into the exhaust air outlet located at the back of the air conditioner.
4. Attach the hose adapter onto the exhaust hose.
5. Attach the hose adapter to the window kit.
POSITIONING THE EXHAUST HOSE
Insert the exhaust hose into the back of the unit and tighten it into place.
Avoid kinks and bends in the exhaust hose. These can cause moist air to accumulate, resulting in
overheating and unexpected shut offs.
The exhaust hose may be extended from 12 inches (300 mm) to 59 inches (1500mm), but for maximum
cooling efficiency, use the shortest length possible.
NSTALLATION
http://www.NewAir.com
8