Replacing The Lcd Assembly - Gateway MG1 Service Manual

Replacing the LCD assembly

v
Tools you need to complete this task:
Flat-blade driver
Phillips #0 screwdriver
Screws removed during this task:
2 black M2.5×3
(Keyboard cover)
2 black M2.5×8 (Hinge
bottom)
To replace the LCD assembly:
1
Complete the steps in
2
If the notebook has wireless networking built in, unplug the wireless antennas by
following the steps in
3
Remove the keyboard cover by following the steps in
cover" on page
4
Remove the keyboard by following the steps in
page 79.
5
Remove the screws on the bottom that secure the LCD panel hinges to the chassis.
Screw
6
Turn the notebook over so the top is facing up.
7
Carefully open the LCD panel to the fully-open position.
www.gateway.com
- OR -
4 black M2.5×3
(Keyboard)
2 black M2.5×8
(Hinge top)
"Preparing the notebook" on page
"Replacing the IEEE 802.11 wireless card" on page
76.
Scribe or non-marring tool
1 long black (Keyboard)
55.
"Replacing the keyboard
"Replacing the keyboard" on
Screw
63.
91