Gateway MG1 Service Manual page 111

2
If the notebook has wireless networking built in, unplug the wireless antennas by
following the steps in
3
Remove the hard drive by following the steps in
page 69.
4
Remove the keyboard cover by following the steps in
cover" on page 76.
5
Remove the keyboard by following the steps in
page 79.
6
Remove the LCD assembly by following the steps in
on page 91.
7
Slide the brown touchpad connector clip to the back of the notebook, then remove
the cable. Be careful not to touch or damage any other components.
8
Turn the notebook over so the bottom is facing up.
9
Remove the screws from the bottom of the notebook.
Screw
Screw
Screw
Screw
10
Turn the notebook over so the top is facing up.
www.gateway.com
"Replacing the IEEE 802.11 wireless card" on page
Screw
"Replacing the hard drive" on
"Replacing the keyboard
"Replacing the keyboard" on
"Replacing the LCD assembly"
Touchpad
connector
Screw
Screw
Screw
63.
105