Gateway MG1 Service Manual page 106

100
CHAPTER 3: Replacing notebook components
9
Remove the screws that secure the LCD panel to the LCD panel lid.
Screw
Screw
10
Carefully raise each of the bottom corners of the LCD panel and replace the old
hinges with new hinges.
11
Replace the screws that were removed in
12
Make sure that the magnet has remained in the magnet bracket.
Magnet bracket and magnet
13
Press the LCD panel front and back together. Press the two halves together in several
places until they click in place. You should find no loose spots or spots where the
two halves do not meet.
14
Replace the LCD panel assembly screws removed in
15
Replace the rubber inserts removed in
16
Replace the LCD assembly by following the steps in
on page 91.
17
Replace the keyboard by following the steps in
page 79.
18
Replace the keyboard cover by following the steps in
cover" on page 76.
19
Turn the notebook over so the bottom is facing up.
20
Reconnect the antenna wires to the wireless card by following the steps in
"Replacing the IEEE 802.11 wireless card" on page
Screw
Screw
Step 9.
Step 7.
Step 6.
"Replacing the LCD assembly"
"Replacing the keyboard" on
"Replacing the keyboard
63.