Panasonic KX-UDS124 Installation Manual page 69

2.
Hold down until "Please wait..." is displayed.
3.
When registration has completed, "Registered" will be displayed.
Note
•
You can register multiple S-PSs continuously. However, PS Registration mode will terminate if no
registrations are detected within 2 minutes (If the IPEI is registered by provisioning, there is no time
limit.). All SIP-CSs controlled by the Super Master CS will enter PS Registration mode at the same
time as the Super Master CS. You can register an S-PS to any of the SIP-CSs.
•
When registering multiple S-PSs, perform the registration procedure on each S-PS individually.
Performing the registration procedure on multiple S-PSs at the same time may result in an error. In this
case, reperform the registration procedure.
•
After registering S-PSs, the Web port will be closed. Refer to the Administrator Guide to open the Web
port again.
•
After registering S-PSs, S-PS firmware update may start automatically. During the firmware update,
the S-PS may reboot up to 3 times. Therefore, you should not remove the battery/batteries of the S-PS.
For registered S-PS
Please refer to "5.1 PS Registration from Web User Interface—Registering S-PSs—For registered S-PSs" in
the Administrator Guide.
4 Deployment Procedure
Installation Guide 69