Programming an Extension Number for the Super Master CS
1.
Click Setup ® PBX Configuration ® Configuration ® Slot.
2.
Click Virtual ® V-UTEXT32.
3.
Move the mouse pointer over the V-UTEXT32 card (Virtual UT Extension Card).
A menu will be shown under the mouse pointer.
4.
Click Port Property.
5.
Enter the desired extension number in the corresponding Extension Number cell.
Note
It is recommended to use Web Maintenance Console in on-line mode to change the extension number and
password for the Super Master CS. If the extension number and password of the Super Master CS are
changed in off-line mode, the change may not take effect correctly. In this case, reset each SIP-CS to let
the change take effect correctly. For details about resetting each SIP-CS, see the Administrator Guide.
4 Deployment Procedure
Installation Guide
55