Configuration Examples for Implementing Management Plane Protection
Command or Action
Step 7
end
or
commit
Example:
RP/0/RP0/CPU0:router(config-mpp-inband-POS0_5_0_0)#
end
or
RP/0/RP0/CPU0:router(config-mpp-inband-POS0_5_0_0)#
commit
Step 8
show mgmt-plane [interface { type instance }]
Example:
RP/0/RP0/CPU0:router# show mgmt-plane interface POS
0/5/0/0
Configuration Examples for Implementing Management Plane
Protection
This section provides the following configuration example:
•
Configuring Management Plane Protection: Example
The following example shows how to configure inband interfaces under MPP:
configure
control-plane
management-plane
inband
Cisco IOS XR System Security Configuration Guide
SC-232
Configuring Management Plane Protection: Example, page SC-232
interface POS0/5/0/0
allow SSH
!
interface POS0/5/0/1
Implementing Management Plane Protection on Cisco IOS XR Software
Purpose
Saves configuration changes.
When you issue the end command, the system
•
prompts you to commit changes:
Uncommitted changes found, commit them
before exiting(yes/no/cancel)?
[cancel]:
Entering yes saves configuration changes to
–
the running configuration file, exits the
configuration session, and returns the
router to EXEC mode.
–
Entering no exits the configuration session
and returns the router to EXEC mode
without committing the configuration
changes.
Entering cancel leaves the router in the
–
current configuration session without
exiting or committing the configuration
changes.
•
Use the commit command to save the
configuration changes to the running
configuration file and remain within the
configuration session.
Displays information about the management plane,
such as type of interface and protocols enabled on
the interface.
(Optional) Use the interface keyword to display
•
the details for a specific interface.