Configuring Sites Example; Links Table - Cisco OL-10426-01 User Manual

Links Table

Configuring Sites Example

This section provides an example for configuring Sites.
Enter the information shown in
Step 1
Table 4-2
Site
Paris
Boston
Denver
Note
Use the left and right arrows to highlight Configure and press Enter.
Step 2
Select Sites and press Enter. A new sites table is displayed.
Step 3
Note
Highlight the Site field by pressing the Down arrow. Type Paris. You have now created a site.
Step 4
Step 5 To modify the NMT default site values, cursor or tab to each of the fields listed in
the data that applies to the Paris site. There are two ways to enter data:
1.
2.
Step 6 Press the down arrow to insert a new line in the table.
Step 7 Repeat Step 4 and Step 5 for Boston, and Step 4 and Step 5 for Denver. The Sites table should look like
the one shown in
Step 8 Press Escape to accept the entries and return to the Configure menu.
Links Table
The Links Table contains topological and cost information about every existing link or possible link
candidate in the network.
Cisco WAN Modeling Tools Guide
4-6
Field Changes for the Sites Table
Type Power IGX
IGX D N
IGX A Y
IGX A Y
Except where noted in this table, each node uses default values.
Select a menu choice by using the up and down arrow keys, or by typing the first letter of the
item selected.
Press the Help key to see a list of choices. Lists of choices are available for most fields that accept
three or more non-numeric values. Make a selection using the cursor and press Enter.
Type directly into the field. Press the Delete key if you make a mistake.
Figure 4-1.
Table 4-2 into the Sites table.
BC (Back FC (Front
Card) Card)
E1 NTC
T1 NTM
T3 BTM
Chapter 4 Configuration Tables and Fields
RLC (Redundant
Link Card)
Y
N
N
Table 4-2, and enter
OL-10426-01, Rev. A0