Before Assembly - Bowflex TreadClimber TC20 Assembly Manual

Select the area where you are going to set up and operate your machine. For safe operation, the location must be on a
hard, level surface. Allow a minimum workout area of 70.5" x 134" (179.1 cm x 340.4 cm).
Basic Assembly Tips
Follow these basic points when you assemble your machine:
• Read and understand the "Important Safety Instructions" before assembly.
• Collect all the pieces necessary for each assembly step.
• Using the recommended wrenches, turn the bolts and nuts to the right (clockwise) to tighten, and the
left (counterclockwise) to loosen, unless instructed otherwise.
• When attaching 2 pieces, lightly lift and look through the bolt holes to help insert the bolt through the
holes.
• The assembly requires 2 people.
• Do not use any power tools for assembly.
Note: The TreadClimber
To determine if your outlet or circuit breaker is GFI, look for a test and reset button on them. If they
have the test and reset button, it is a GFI outlet or circuit breaker.
Machine Mat
The Bowfl ex TreadClimber
® ®
a layer of protection to your fl oor. The rubber machine mat provides a non-slip, rubber surface which limits static
discharge and reduces the possibility of display or running errors. If possible, put your Bowfl ex
Machine Mat in your selected workout area before you begin assembly.
To order the optional machine mat, go to: www.bowfl ex.com, or call 1 (800) 605–3369.
fi tness machine is designed to plug into a grounded, non-GFI outlet only.
®
Machine Mat is an optional accessory that helps keep your workout area clear and adds

Before Assembly

TreadClimber
® ®
5