Dmx Capture Menu; Control Panel Shortcuts - Martin MAC 350 Entour User Manual

Menu Item
RATE
QUAL
DMXL
STCO
SHUT
–
PTFB
ADJ
SERV
To access
this menu,
CAL
hold
[Enter]
(OF = offset)
pressed for
a few
seconds
DFOF
PCBT
UPLD

DMX capture menu

The DMX capture menu in SA
Item Item item
GDMX DMX STOR

Control panel shortcuts

The following shortcuts are available using the buttons in the MAC 350 Entour control panel:
40
Options
EFSP
ON
OFF
D OF
C OF
G OF
GROF
I OF
F OF
P OF
T OF
SURE
SURE
SURE
Table 4: Control menu
PROG
Options Notes
Add the scene currently being sent by DMX to the end of the stand-alone
ADD
sequence.
INS
Insert the scene currently being sent by DMX before the current scene.
Table 5: DMX capture menu
Shortcut
Hold [Menu] and press [Up]
Hold [Menu] and [Enter] during fixture reset
Hold [Up] and press [Down]
Table 6: Control panel shortcuts
MAC 350 Entour user manual
Notes (Default settings in bold print)
DMX transmission speed in packets per second
Percent of packets received without errors
Decimal value of the DMX start code
DMX value (0 - 255) received on each channel
Enable pan/tilt position feedback/correction system
Disable pan/tilt feedback for service (this setting is not saved when
fixture is reset)
Effects adjustment menu (for service use: for full details of this
menu, see "Adjustment submenu" on page 41)
LED output calibration
Color wheel calibration
Rotating gobo wheel calibration
Rotating gobo calibration
Iris calibration
Focus calibration
Pan calibration
Tilt calibration
Load factory effects calibration settings
PCB test: for service use only
Manually set fixture to receive software upload
GDMX
contains the following options:
Function
Reset fixture
Freeze pan and tilt
Invert display