Display Messages - Martin MAC 350 Entour User Manual

Display messages

Message
RST
(Reset)
SRST
(Serial reset)
****
or
CSER
(Check-sum error)
HTSE
(Head temperature sensor error)
YTSE
(Yoke temperature sensor error)
LTCO
(LED temperature cutoff)
EFHA
MERR
(Memory error)
OPER
(Onboard programming error)
RAME
(RAM error)
COER
(Color wheel error)
G1ER
(Gobo wheel error)
FBEP
(Feedback error pan)
FBET
(Feedback error tilt)
FBER
(Feedback error pan/tilt)
PAER
(Pan time-out)
TIER
(Tilt time-out)
FOER
(Focus time-out)
HTER
(Head temperature error)
YTER
(Yoke temperature error)
TL1E - TL7E
(Temperature error, LED 1 - LED7)
F1ER
(F1 = large fan on back of head)
F2ER
(F1 = small internal fan)
DRE1 - DRE7
(Driver error, drivers 1 - 7)
DPER
(Display programming error)
SL1E - SL7E
(Sensor error, sensors 1 - 7)
42
Appears when...
... the fixture is indexing effects at startup.
... the fixture has received a reset command
via DMX.
...there is no communication between the
control panel and motherboard (this display
appears briefly when powering the fixture on).
...a fixture software (firmware) upload is
unsuccessful.
...one of the sensors is reporting temperature
above maximum or there is a problem with the
temperature sensing circuit. LEDs are shut
down.
...the effects hatch is open and power is
applied.
...the EEPROM memory cannot be read.
....there is a software programming error.
....there is a RAM error.
...there is a malfunction in the color wheel or
gobo wheel positioning system.
...the pan and/or tilt correction systems cannot
correct a loss of step (or there is a malfunction
in the pan/tilt monitoring circuit such as a
defective sensor). After a time-out, the head
stops in a random position.
...there is a malfunction in the position
indexing circuit for pan, tilt or focus. After the
time-out, the fixture will establish a
mechanical stop and continue to work,
although calibration will be imprecise.
...there is a malfunction in one of the
temperature sensing circuits.
...there is a fan feedback error.
...one or more motor drivers fail.
...there is a display error.
...a sensor reports that it is short-circuited or
open.
Table 6: Display messages
MAC 350 Entour user manual
What to do
Wait for reset to complete.
Wait for reset to complete.
PERS→DRES
You can set
to prevent accidental DMX reset
commands.
Check fuses.
Check cable and connectors between
control panel and motherboard.
Reinstall fixture software.
Contact Martin service if problem
continues.
Repeat the upload. Contact Martin
service personnel if problem continues.
Ensure free airflow around fixture.
Clean fixture.
Check that ambient temperature does
not exceed max. permitted level.
Contact Martin service personnel if
problem continues.
If you do not need access to effects,
close the effects hatch to restore
normal operation.
If this message appears while you are
trying to reset the fixture, close the
effects hatch fully and start the reset
again.
Note that the effects hatch must be
firmly clipped into the fully closed
position.
Reset fixture.
If a pan/tilt error is displayed when you
attempt to reset the fixture, check that
the effects hatch is fully closed.
Upload new fixture software.
Contact Martin service personnel if
problem continues.
OFF
to