Checking The Installation; Linking Automower™ To The Charging Station - Husqvarna AUTOMOWER Operator's Manual

7. Refit the cover on the charging station. Ensure
the three guides on the charging station enter the
right holes in the cover.

3.6 Checking the installation

Check the loop signal by looking to see what
indication the green LED on the charging station is
giving.
• Steady light = the signal is okay.
• Flashing once every other second = break in the
loop and no signal found.
• Flashing twice every other second = weak signal.
This may be due to the boundary wire exceeding
1600 ft or that the cable is damaged. If the
mower works, it is not a problem.
3.7 Linking Automower™ to the
charging station
1. Place the Automower in the charging station.
2. Open the solar cell panel using the cut-out on the
back edge of the panel to access the control
panel.
3. Set the main switch to the ON position.
A start-up sequence begins when Automower is
started for the first time. The following is
requested: Language, time format, correct time,
date format, date, and four-digit PIN code. All
combinations except 0000 are permitted.
When you have chosen a PIN code with Automower
placed in the charging station, the mower and charging
station are then linked to each other.
3. INSTALLATION
3012-270
3012-282
3012-823
English - 31