Checking The Installation - Husqvarna AUTOMOWER 305 Operator's Manual

6. Connect the guide wire to the boundary wire with
the help of a solderless coupler:
Insert the boundary wire in each of the holes in
the coupler. Insert the guide wire in the center
hole in the connector. Check that the wires are
fully inserted into the connector so that the ends
are visible through the transparent area on the
other side of the connector.
Use pliers to completely compress the button on
the connector.
It does not matter which holes are used to
connect each wire.
7. Staple down/bury the connector in the lawn.
IMPORTANT INFORMATION
The function of the guide wire varies
depending on how the working area appears.
It is therefore recommended to test the
installation with the help of the function Test
IN (2-3-1), see 6.4 Installation (2).
IMPORTANT INFORMATION
The guide wire may not cross the boundary
wire, for instance a boundary wire that is laid
out to an island.

3.7 Checking the installation

Check the loop signal by inspecting the indicator
lamp on the charging station.
• Steady green light = good signals.
• Flashing blue light = interruption in the boundary
wire, no signal.
• Flashing yellow light = interruption in the guide
wire, no guide signal.
• Flashing red light = interruption in the charging
station's antenna plate, no remote signal
available. The fault should be rectified by an
authorized dealer.
• Steady blue light = weak signal. This may
depend on the boundary wire being over 820 ft
(250 m) in length or that the wire is damaged. If
the mower still works, this is not a problem.
• Steady red light = fault in a circuit board in the
charging station. The fault should be rectified by
an authorized dealer.
See 9.2 Indicator light on the charging station on
page 61 if the light is not a solid green.
3. INSTALLATION
English - 31