Checking The Installation; First Start-Up And Calibration; Pairing With The Automower ® Connect App - Husqvarna AUTOMOWER 310 Operator's Manual

easier if an eyelet has been made on the boundary
wire as outlined in the previous description. See
Laying the boundary wire on page 16 .
8. Connect the guide wire to the boundary wire using a
coupler:
a) Insert the boundary wire and guide wire in the
coupler. Check that the wires are fully inserted
into the coupler so that the ends are visible
through the transparent area on the other side of
the coupler.
b) Use a multigrip pliers to completely compress
the button on the coupler. It does not matter
which holes are used to connect each wire.
9. Staple down or bury the splice in the lawn.
CAUTION: The guide wire may not cross the
boundary wire, for instance a boundary wire that
is laid out to an island.
840 - 001 -

3.8 Checking the installation

Check the loop signal by inspecting the indicator lamp
on the charging station.
See Indicator lamp in the charging station on page 52 if
the lamp does not indicate a solid or flashing green light.

3.9 First start-up and calibration

When the main switch is set to position
time, a start-up sequence in the robotic lawnmower's
menu must be carried out as well as an automatic
calibration of the guide signal.
1. Open the hatch by pressing the STOP button.
2. Set the main switch to position
A start-up sequence begins when the robotic
lawnmower is started for the first time. The following
is requested:
• Language.
• Country
• Date
• Time
• Selection and confirmation of personal PIN code.
All combinations except 0000 are permitted.
MEMO page at the beginning of the
Note: Use the
manual to make a note of the PIN code.
3. Place the robotic lawnmower in the charging station
and press START. The robotic lawnmower will now
begin to calibrate the guide wire.
Press START and close the hatch. The calibration is
performed by the robotic lawnmower backing out of
the charging station and running a calibration
process in front of the charging station. When this is
completed, mowing can begin.
3.10 Pairing with the Automower
app
If the first start-up process already has been carried
through, the next operator follows the normal pairing
process.
The normal pairing process between the Automower
Connect app and the product involves the following
steps:
1. Download the Automower
an account. Refer to
2. Log in to your Automower
app.
3. Set the Main switch to position
1 for the first
1 .
®
Connect
®
Connect app and create
Connectivity on page 21 .
®
Connect account in the
1 on the product.
Installation - 19
®