TEC MA-600 Series Programming Manual page 174

6. TERMINAL FILE PROGRAMMING
Operation
Depress the [↓] key twice.
Depress the [3] or [Enter] key.
Depress the [↓] key twice.
Depress the [Enter] key.
(Key Code 3 "CHECK" is selected.)
Depress the [↓] key, then depress the
[→] key.
Depress the [Enter] key.
The [End] key depression allows the
ECR to end this programming.
(continued from the previous page)
LCD Display
6-154
6.36 Key Status Programming
Remarks
The cursor is moved on to "3 KEY
FUNCTION".
"3 KEY FUNCTION" is selected.
The cursor is moved on to "03 CHECK".
"03 CHECK" is selected.
While ? is shown on the upper-right corner
of the LCD display screen, the [?] key
depression results in that the following
guidance message appears on the LCD
display.
The Bit Nos. currently programmed are
displayed on the 7-segment numeric display.
By the [→] key depression, Bit No. 2 status
is changed from "Y" to "N".
A long receipt is issued and the display
returns to Main Menu screen.
31-10-2005 MON #3001
KEY STATUS
#03----------------------------7
0033 13:27TM
EO3-11106