Yamaha QL5 Reference Manual page 7

If the destination bus channels are two mono channels:
1
2
3
1
SEND knob
Adjusts the send level to the corresponding bus.
2
PRE indicator
Indicates the send point of the corresponding bus. If the PRE button on the MIX SEND
8ch screen is turned ON, this PRE indicator will be turned on.
3
ON button
Switches the send signal to the corresponding bus on or off.
If the destination bus is a stereo channel:
1
1
SEND/PAN knob
The right-hand knob adjusts the level of the signal sent to a pair of bus channels (even-
numbered and odd-numbered). The left-hand knob adjusts the pan and balance of the
same signal.
2
PRE indicator
Indicates the send point of the corresponding bus. If the PRE button on the MIX SEND
8ch screen is turned ON, this PRE indicator will be turned on.
3
ON button
Switches the send signal to the two buses on or off.
NOTE
• If the indices of a SEND/PAN knob are white, the send point is assigned as PRE; if the indices
are black, it is assigned as POST.
• If the send point is PRE, you can specify the PRE point as either VARI [PRE EQ] or VARI [PRE
FADER] in the BUS SETUP popup that appears when you press the SETUP button  BUS
SETUP button.
• If the type of the destination bus is set to FIXED, controllers
displayed. The send level will be fixed at nominal level, and the send point will be fixed at POST
FADER. For details, see "Basic settings for MIX buses and MATRIX
• Press the SEND knob or PAN knob on screen to open the SEND 8ch window.
2
3
1 2
– mentioned above will not be
buses" on page 189.
 GAIN/PATCH field
This field enables you to make HA (head amp) analog or digital gain settings. You can also
view the operational status of the head amp.
1
GAIN knob
Sets the analog gain/digital gain of the head amp.
Press the knob to open the GAIN/PATCH 1ch
window.
2
GC indicator
Indicates the level of the signal output to the audio
network if the Gain Compensation function is
turned on.
3
OVER indicator
Warns you when the signal is clipping.
4
Ø (Phase) indicator
Indicates the status of the phase setting.
5
+48V indicator
Indicates the phantom power (+48V) on or off status for the head amp.
6
HPF ON indicator
Indicates the HPF on/off status of the external head amp.
7
AG-DG LINK indicator
Indicates a link between the analog gain and digital gain of the head amp.
8
Digital/Analog gain value
If analog gain is assigned to the GAIN knob, the digital gain value is shown here. If digital
gain is assigned to the GAIN knob, the analog gain value is shown here.
NOTE
• For an input channel that is patched to an input that has no head amp,
will not be shown. For an output channel,
• If GAIN KNOB FUNCTION is set to DIGITAL GAIN in the USER SETUP PREFERENCE
screen, the digital gain knob will appear for
details, refer to "Making HA (Head Amp)
7
SELECTED CHANNEL section
3
2
1
5 6 7 8
1 2 5 6
, , ,
1 7
– will not be shown.
1 2 5 6 7
, and , , , and will not be shown. For
settings" on page 26.
Reference Manual
4
7
, and