Switching The Entire Phantom Power Supply On/Off; Specifying The Brightness Of The Touch Screen, Leds, Channel Name Displays, And Lamps - Yamaha QL5 Reference Manual

4
PAN LINK button
This button appears if SIGNAL TYPE is set to STEREO and the bus type is set to VARI. If
the button is on, the pan setting of signals sent from input channels to the
corresponding two buses will link with the STEREO bus pan setting.
5
Tabs
Enable you to switch between the MIX and MATRIX buses.
Switching the entire phantom power supply on/
off
STEP
1. In the Function Access Area, press the SETUP button to access the SETUP screen.
2. In the center of the SETUP screen, press the +48V MASTER field's ON button or OFF
button.
If this button is off, phantom power will not be supplied even if the +48V button of an
OMNI jack input channel or TALKBACK IN is on.
SETUP screen
NOTE
This +48V MASTER setting does not affect the inputs of external racks such as DANTE inputs
(I/O devices). Each rack has a +48V MASTER switch, and will operate according to its setting.
Specifying the brightness of the touch screen,
LEDs, channel name displays, and lamps
Follow the steps below to specify the brightness of the touch screen, top panel LEDs, channel
name displays, and lamps connected to the rear panel LAMP connectors. You can save two
different brightness settings in bank A and B, and switch between them rapidly if desired.
STEP
1. In the Function Access Area, press the SETUP button.
2. In the field located in the right of the bottom row of the SETUP screen, press the
BANK A or BANK B button.
3. Use the [TOUCH AND TURN] knob to adjust the brightness of each item.
NOTE
You can also assign this parameter to a USER DEFINED key, and press that key to switch
between banks A and B.
SETUP screen (brightness setting field)
1 2 3
1
BANK A/B buttons
Switch between the brightness settings.
 CONTRAST field
2
NAME
Adjusts the contrast of the characters of the channel name displays on the top panel.
 BRIGHTNESS field
3
NAME
Adjusts the brightness of the channel name displays on the top panel.
This will also change the CH COLOR brightness and LED brightness in the lower part of
the [TOUCH AND TURN] knob. If you want to adjust the CH COLOR brightness after
setting the name display brightness, use the CH COLOR knob.
4
CH COLOR
Adjusts the brightness of the channel colors on the top panel.
This lets you apply a relative adjustment to only the channel color brightness without
changing the channel name display brightness.
190
4 5 6 7
Setup
Reference Manual