Removing The Hy Card; Power Supply; Connecting The Ac Power Cord; Turning The Power On And Off - Yamaha RIVAGE PM Series Owner's Manual

Removing the HY Card

1.
Make sure that both power indicators are off.
Caution
Installing or removing a card while the power is on may
lead to component failure or electric shock.
2.
Completely loosen the screws that hold the
card in place.
3.
Unlock the card by pressing the red button on
the card installation lever.
4.
Press down the card installation lever to pull
out the card.
5.
Replace the stored slot cover and affix it with
the screws.

Power Supply

Connecting the AC Power
Cord
1.
Turn off both power switches A and B on the
unit.
2.
Connect one of the supplied power cords to
AC IN connector (A), and the other to AC IN
connector (B).
3.
Connect the other end of each power cord to
an AC outlet.
NOTE
• To disconnect the power cords, remove the cables in the
order of steps 1➝3➝2 in the procedure described
above.
• To disconnect the power
cord, remove it while
pressing the latch on the
plug.
Warning
Use only the supplied AC power cords. Using other cables may
lead to overheating or electric shock.
Caution
Be sure to turn off the power to the unit before connecting or
disconnecting the power cord.
NOTICE
Even when the power switches are turned off, a small amount of
current is flowing through the unit. If you plan not to use the unit
for a long period of time, be sure to remove the power cords from
the AC outlets.
Turning the Power On and
Off
When you turn on the power to the unit, be sure to turn
on the power to the power amplifier last to avoid speaker
damage. Before you turn off the power to the unit, first
turn off the power to the power amplifier.
NOTE
To maintain power supply redundancy, turn both power switches
A and B ON or OFF together. If only one power switch is ON, the
LCD will display an error message and the color indicator will
light up yellow.
DSP-RX(-EX) Owner's Manual 15