Installation Troubleshooting; Initial Start-Up - U-Line Echelon 2275DWRR Installation Manual

4. Using two of the screws (C) supplied, fasten the screws
through the bracket and into the counter, cabinet or wall.
IMPORTANT
Certain cabinets or countertops may require special
fasteners or additional wood blocking to anchor properly.
Make sure the screws are back far enough so they do not
damage any exposed front surface of the cabinet.

Installation Troubleshooting

Q:
Problem
The drawer remains open unless it is pushed closed.
A:
Solution
The drawer should be self-closing when it is open
approximately 8". If it is not, re-check leveling from front
to back of the unit and readjust if necessary.
www.U-LineService.com
2275DWRR — Drawer Model Refrigerator
CAUTION
9 Start-Up for the First Time

Initial Start-Up

Once installation and leveling is complete, the unit is
ready for initial start-up and operation. Open the top
drawer press and hold the POWER icon (see Figure
27,1)on the display panel for aproximately ten seconds
until the °F symbol flashes and release.
All U-line units are shipped from the factory with controls
that are preset. No initial adjustments are required.
U-Line recommends that the unit be allowed to run
overnight prior to loading the refrigerator with
product.
Electronic Control Panel
The electronic control with digital display (Figure 27) is
lconfigured to show a single temperature
continuously.This set-point temperature is a base number
used by the controller to maintain the temperature zone
in your unit. The factory default set-point is 38°F. This set-
point temperature is used as a gauge if further
temperature adjustments are required.
1
Figure 27
For further information about the electronic control, see
the Use and Care Guide.
14
IMPORTANT
2 3 4 5
ULIN_0058_A
09/2007