Installation Troubleshooting; Initial Start-Up - U-Line Echelon CO2175DWR Installation Manual

Echelon series combo drawer refrigerator/freezer/ice maker
Hide thumbs Also See for Echelon CO2175DWR:
Table of Contents

Advertisement

4. Using two of the screws (C) supplied, fasten the screws
through the bracket and into the counter, cabinet or wall.
IMPORTANT
Certain cabinets or countertops may require special
fasteners or additional wood blocking to anchor properly.
Make sure the screws are back far enough so they do not
damage any exposed front surface of the cabinet.

Installation Troubleshooting

Q:
Problem
Water is leaking under the unit.
A:
Solution
A water leak under the unit is most likely caused by a bad
connection in the water supply line. Make sure the water
line's brass fitting is screwed tight to its valve and
threaded correctly.
Q:
Problem
The drawer remains open unless it is pushed closed.
A:
Solution
The drawer should be self-closing when it is open
approximately 8". If it is not, re-check leveling from front
to back of the unit and readjust if necessary.
06/2006
CO2175DWR — Ice Maker/Refrigerator
CAUTION
10 Start-Up for the First Time

Initial Start-Up

All U-Line units are shipped from the factory with the
controls that are preset. No initial adjustments are
required.
Once installation and leveling is complete, the unit is
ready for initial start-up and operation. Open the top
drawer, press and hold the POWER icon (see Figure 31,1)
on the display panel for aproximately ten seconds until
the °F symbol flashes and release.
U-Line recommends that the unit be allowed to run
overnight and make ice prior to loading the
refrigerator and/or freezer with product.
1. As soon as the icemaker
mold reaches the proper
temperature, the ice
maker mechanism will fill
the mold with water.
Note: There is an interior
light in each drawer which
illuminates when the drawer
is opened.
Note: The first cubes may be
small because of air in the
water line. After two hours, cubes will be standard size.
2. The ice maker will continue to produce until the bin is
full. You may interrupt production by raising the bin arm
into an upright and locked position (see Figure 30).
While the bin arm is locked, the unit will maintain
temperature for ice storage.
It is possible that dirt or scale will dislodge in the water
line. Always throw away all ice cubes made during the
first twenty-four (24) hours of operation.
15
IMPORTANT
Figure 30
IMPORTANT
www.U-LineService.com

Advertisement

Table of Contents
loading

Table of Contents