Table of Contents
Advertisement
Power supply removal
Figure 20
Replacement
To replace a redundant power supply:
1. Remove the replacement power supply from its shipping
2. Inspect the rear of the power supply for bent or broken connector
3. Position the power supply in the rear of the router. While
4. Tighten the thumb screws.
5. Connect the AC power cord to the power supply and to a facility
6. Review in either Element Manager or SANvergence Manager to
7. If installed in a cabinet, close the equipment cabinet door.
container.
pins that may have been damaged during shipping. If any pins
are damaged, obtain a new power supply.
supporting the power supply with one hand, insert it into the
router chassis.
power source.
verify the error has been cleared.
Chapter 5: Removal and replacement procedures
73
Advertisement
Table of Contents
Troubleshooting
