Table of Contents
Advertisement
Figure 12
Troubleshooting overview
48
SAN16M-R SAN Router Installation And Service Manual
Table 18
Resetting the system
Dialog box
FC/Ethernet Port Configuration
Configuration>Port>FC/Ethernet
iFCP Setup
Configuration>iFCP>Setup
Management Port Configuration
Configuration>Port>Management
Selecting Reset System from the File menu displays the Reset Options
dialog box
(Figure
12).
Reset Options dialog box
•
Reset SAN Router - This resets the hardware and firmware while
maintaining the existing configuration values. Be sure to select
this option if you want to maintain any values you have set
through configuration dialog boxes.
Reset to Factory defaults - This resets the hardware and firmware and
restores the configuration values to the factory-defaults. Refer to
Router firmware default values
settings. Make sure that no conflicts will occur by resetting to these
defaults.
If you are experiencing problems with the SAN Router, the first and
most logical step is to make certain that all physical connections are
in place and connected properly as described in
Parameter changed requiring reset
The TCP port address, subnet mask, next hop
gateway, address, internal address
The local mSAN ID.
The management address and subnet mask
address.
on page 32 for a list of these default
Table 19, Physical
SAN
Advertisement
Table of Contents
Troubleshooting
