Installing An Sfp Device - IBM TotalStorage SAN16M-R SAN Installation And Service Manual

Installing an SFP device

RJ45 pinout description
Table 14
Pin number Signal
6 Rx-
7 Not used
8 Not used
CAUTION
Data processing environments can contain equipment transmitting
on system links with laser modules that operate at greater than
Class 1 power levels. For this reason, never look into the end of an
optical fiber cable or open receptacle.
(C027)
SFP transceivers are usually shipped with protective rubber plugs
installed. If you do not plan to immediately connect fiber cable to the
SFP after installation, leave the protective plugs installed.
To connect an SFP device, follow these steps:
1. Insert the SFP through the port cover into the connector until the
connector is firmly connected to the SFP. You should hear an
audible click as it snaps into place.
2. Remove the protective plugs.
3. Install the fiber cabling.
Chapter 2: Installing and connecting the SAN Router
Comment
100 Ω termination.
100 Ω termination.
31