Resetting The System - IBM TotalStorage SAN16M-R SAN Installation And Service Manual

Resetting the system

The dialog box shows the previous version, build date, the
active/inactive status of both E/OSi firmware locations, the TFTP
Server IP address, and the full path and filename of the existing
firmware.
3. Enter or edit the TFTP server IP address where the bootrom.bin
file is stored.
4. Enter or edit the fully qualified path and file name on the TFTP
server for the new bootrom.bin file.
5. Click the Download button.
6. When the download completes, do not click Activate on the dialog
box. Instead, reset the SAN Router. This will activate the new
bootrom with the current version of E/OSi firmware installed on
the system.
To reset the SAN Router, select Reset System from the File menu.
When the Reset Options dialog box displays, select the first option
to Reset System.
Certain configuration changes require you to reset the SAN Router
using File>Reset System before they take effect. These occurrences are
described in previous chapters and are listed below for reference.
Resetting the system
Table 18
Dialog box
Inband Address Configuration
Configuration>System>Inband Address
Advanced FC Port Configuration
Configuration>Port>Advanced FC Port
Firmware Upgrade
File>Firmware Upgrade
Parameter changed requiring reset
The Router's inband address, subnet mask
address, and gateway address.
The error detection and resource allocation
timeout values.
The activate boot location.
Chapter 3: Maintenance and troubleshooting
47