Replacing An Scb; Powering Off The Services Gateway - Juniper SRX 5600 Installation Instructions Manual

SRX 5600 and SRX 5800 Services Gateway Switch Control Board Installation Instructions
Table 2: Switch Control Board LEDs

Replacing an SCB

The services gateway can have up to three SCBs. They are located in the front of the
chassis in the slots marked
2/6
weighs approximately 9.6 lb (4.4 kg).
Before you replace an SCB or a Routing Engine, you must power off the services
gateway (see "Powering Off the Services Gateway" on page 4). To replace an SCB,
use the following procedures:

Powering Off the Services Gateway

Before installing or removing SCBs you must power off the services gateway:
1.
2.
4
Replacing an SCB
Label Color State
Green On steadily
FABRIC
ACTIVE
Green On steadily
FABRIC
ONLY
Off
Green On steadily
OK/FAIL
Off
Red On steadily
on an SRX 5800 services gateway. With a Routing Engine installed, the SCB
Powering Off the Services Gateway on page 4
Operating and Positioning the SCB Ejectors on page 5
Removing an SCB on page 5
Installing an SCB on page 6
On the external management device connected to the Routing Engine, issue the
operational mode command. The command shuts down the
request system halt
Routing Engine cleanly, so its state information is preserved.
user@host> request system halt
Wait until a message appears on the console confirming that the operating system
has halted. For more information about the command, see the JUNOS System
Basics and Services Command Reference.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist and
connect the strap to one of the ESD points on the chassis. For more information
about ESD, see "Preventing Electrostatic Discharge Damage" on page 8.
Description
Fabric is in active mode.
SCB operates in fabric-only mode.
SCB operates in fabric/control board mode.
SCB is online.
SCB is offline.
SCB has failed.
0 and 1 on an SRX 5600 services gateway and 0 , 1 , and