Sdg Router Event Log Levels - IBM TotalStorage DS4000 Hardware Maintenance Manual

loggerDump [number]
loggerDumpCurrent [level]
126
IBM TotalStorage DS4000: Hardware Maintenance Manual
The command causes the SDG Router to run an immediate, level 4 health
check. Results display that indicate which devices or subsystems failed the
check.
Router> hlthChkNow
The loggerDump command dumps records from the system event log to
the console. You can use a numeric parameter to indicate the number of
events to display. With no parameter specified, all events in the log file
display starting with the most recent events, as the following example
shows.
Router > loggerDump 4
*** Dumping 4 (1018 through 1021) of 1021 records ***
000008 1018 0d:00h:00m:07s:22t -- SCSI 2: Bus RESET
000009 1019 0d:00h:00m:07s:22t -- Target device added: index 0, handle 0xc0ec2600
000010 1020 0d:00h:00m:08s:18t -- Target device added: index 10, handle 0xc0ad2590
000011 1021 0d:00h:00m:08s:28t -- SCSI 2: New Device at Id 6, Lun 0
Router >
The loggerDumpCurrent command dumps records from the system event
log to the console. Only the records that were logged since the system was
last started are dumped. Level specifies the event log level for the events
as shown in Table 54.
Table 54. SDG Router event log levels
Level Name
0 Private
1 Notice
2 Warning
3 Information
The following example shows a dump after a typical start sequence with
four target devices added (one additional device shows, which is the
command and control LUN of the SDG Router itself).
Router > loggerDumpCurrent 1
*** Dumping 9 (1010 through 1018) current records with level >= 0 ***
000001 0d:00h:00m:05s:56t -- NOTICE: CS and LOGGING STARTED
000002 0d:00h:00m:07s:19t -- FCAL 1: LIP occurred
000003 0d:00h:00m:07s:19t -- FCAL 1: Loop up
000004 0d:00h:00m:07s:22t -- SCSI 1: Bus RESET
000005 0d:00h:00m:07s:22t -- SCSI 2: Bus RESET
000006 0d:00h:00m:07s:22t -- Target device added:index 0, handle 0xc0ec2600
000007 0d:00h:00m:08s:18t -- Target device added: index 9, handle 0xc1f9e090
000008 0d:00h:00m:08s:18t -- Target device added: index 10, handle 0xc0ad2590
000009 0d:00h:00m:08s:28t -- SCSI 2: New Device at Id 6, Lun 0
value = 0 = 0x0
Router >
Explanation
Events that are never shown by the remote event
viewer but are recorded in the SDG Router event
log
Conditions that should always be reported, such
as temperature alarms and device removals
Events that might result in a later problem
Events that are not errors or warnings